Shopping Bag

0 item(s) in cart/ total: $0    view cart
XBee Shield V1.1 by Seeedstudio
Seeedstudio XBee shield

XBee Shield V1.1 by Seeedstudio

Your Price:$13.50
Discontinued
Part Number:ARD-0037-NKC
An Xbee shield allows an Arduino board to communicate wirelessly using Zigbee. It is based on the Xbee module from MaxStream. The module can communicate up to 100 feet indoors or 300 feet outdoors (with line-of-sight). It can be used as a serial/usb replacement or you can put it into a command mode and configure it for a variety of broadcast and mesh networking options. The shields breaks out each of the Xbee's pins to a through-hole solder pad. It also provides female pin headers for use of digital pins 2 to 7 and the analog inputs, which are covered by the shield (digital pins 8 to 13 are not obstructed by the shield, so you can use the headers on the board itself).

Features added in V1.1



  1. 31mm*41mm board outline
  2. Communication with Arduino/seeeduino
    1. Via pin11,12 software Serial(Status 1/3)
    2. Via hardware Serial(Status 4)
  3. Setting by X-CTU via USB (Status 2)
  4. Breakout all pins


Seeed Studio's Xbee shield is derived from Arduino Xbee shield, with following features:

  1. Smaller form
  2. SMT package for most of the components
  3. Cost reduction


To use X-CTU with Seeeduino, please upload following sketch

void setup() { DDRB=0; DDRC=0; DDRD=0; }

void loop() { }

Download board drawing

Related Items

Recently Viewed Items